NOTE OF CAUTION: Calculations are approximate. Tonnage requirements and ability to safely punch required hole depends on quality of equipment and tooling. Piranha is not responsible for inaccuracies or results. Due to extreme pressures generated when punching, care must be taken to not exceed the strength of the tooling.
For example, when punching through 60,000 psi material, NEVER attempt to punch a hole smaller in diameter than material thickness. Additional safety margins must be considered if tensile strength of material is higher than 60,000 psi.
DIRECTIONS: Calculator will accept fractional numbers in decimal format only
For material less than 1 inch enter in the following format: 0.5