P-70 Single Operator Ironworker

The Piranha Model P-70 picks up where the P-50 leaves off – for applications requiring more tonnage.

The P-70 has more standard workstations than any other ironworker in its class. This includes punching, bending, bar shear, angle shear, round bar shear, and an integrated coper/notcher.
The P-70 also has a dovetail slide that allows an operator to switch from punching to bending in just a few seconds (watch the video)
Furthermore, the P-70 has full electrical control of its stroke with a footswitch and limit switch stroke controls.
The no slug-loss shearing saves material, keeps the machine area cleaner, and offers larger material capacity than the competition. A wide variety of optional tooling is available to enhance the P-70's capabilities.
Piranha's incomparable integrated coper/notcher station outperforms any other ironworker. Notch from thick to thin, remove the full leg from angle iron, shave even the smallest piece from the end of the work piece, and maintain total control of the part – from any angle.

So, when comparing ironworkers, look at the complete package.

Standard Features

Complete Punching Attachment with split dove tail mounting
5 Punch and Die sets
12" bending Attachment with split dove tail mounting
Automatic Urethane Hold Down on the Punch Stripper and on Angle
Plate and Bar Shear
Front and rear 5 position joy stick controls (electric) with jog up & down, fast up & down, neutral
Remote Electric Foot Switch that can be connected at either end of the machine
Electric Limit Switches that can be set for stroke control when using foot control
Set of Round Bar Knives [2 way] (customers choice to 2)
Set of 14.50 Plate Shear Knives [4 way]
Extra Blank Knife to extend shear to 18"
Set of Angle Knives [8 way top] [4 way bottom]
Set of Coper Knives [2 way top] [4 way bottom]
Chip Buckets (2 each)
Extra Oil Filter
Coupling Wrench & 3/8" Allen Wrench
Integral Lifting Lug for instant portability

Throat Depth	10"	Coper-Notcher (Tons) (Max.)	75 3-1/2" x 5" x 3/8"
Open Height	15"	Bending Attach. (std.) (Optional Length)	12" 24"
Closed Height w/o Die Block	10-1/8"	Punch End Strokes Per Minute	30 @ 3/4"
Stroke Length	4-7/8"	Work Station Height Approx.	42"
Platen Table Size (D-W)	12" x 21"	Hydraulics Pump GPM System R/V PSI	15 2600
Punch Hole Size (Max. Material) Max. Hole Size (Material)	70 Tons 1-3/16" (3/4") 4-1/2" (3/16")	Fluid Capacity (gal.)	25
Plate Shear	18" Long 1" x 6" 3/4" x 12" 1/2" x 18"	Motor Std. 230/460 3 Ph. 1800 RPM Opt Phase & Voltage Available	15 HP 3 Ph.
Angle Shear	5" x 5" 1/2"	Dimensions (Net) W-L-H Approx.	31" x 79" x 64"
Bar Shear Round (min. to max.) Square (min. to max.)	1/2" to 2" 1/2" to 1-3/8"	Weight (Net) Lbs. Approx.	4250